Block RAM-based architecture for real-time reconfiguration using Xilinx® FPGAs
DOI:
https://doi.org/10.18489/sacj.v56i1.252Keywords:
FPGA, reconfiguration, architecture, real-time, BRAMAbstract
Despite the advantages dynamic reconfiguration adds to a system, it only improves system performance if the execution time exceeds the configuration time. As a result, dynamic reconfiguration is only capable of improving the performance of quasi-static applications. In order to improve the performance of dynamic applications, researchers focus on improving the reconfiguration throughput. These approaches are mostly limited by the bus commonly used to connect the configuration controller to the memory, which contributes to the configuration time. A method proposed to ameliorate this overhead is an architecture utilizing localised block RAM (BRAM) connected to the configuration controller to store the configuration bitstream. The aim of this paper is to illustrate the advantages of the proposed architecture, especially for reconfiguring real-time applications. This is done by validating the throughput of the architecture and comparing this to the maximum theoretical throughput of the internal configuration access port (ICAP). It was found that the proposed architecture is capable of reconfiguring an application within a time-frame suitable for real-time reconfiguration. The drawback of this method is that the BRAM is extremely limited and only a discrete set of configurations can be stored. This paper also proposes a method on how this can be mitigated without affecting the throughput.Downloads
Published
2015-07-11
Issue
Section
Research Papers (general)
License
Copyright of all work published here subsists in the authors. While SACJ retains right of first publication, subsequent re-publication is expressly permitted provided the original SACJ publication is acknowledged and cited, according to the terms detailed below. If plagiarism is detected during review, a paper may be summarily rejected and will not be accepted unless even minor infringements are corrected. Should plagiarism be detected after a paper is published, the Editor reserves the right to withdraw a paper from publication. We expect authors to be honest in representing work as their own, and to respect the time and effort our reviewers put in without an undue burden of policing plagiarism, and hence take violations seriously. SACJ applies the Creative Commons Attribution NonCommercial 4.0 License (CC BY-NC 4.0) to all papers published in this journal. Authors who publish with SACJ agree to the following:- Authors retain copyright and grant SACJ right of first publication. The work is additionally licensed under a Creative Commons Attribution Non-Commercial License that requires others who share the work to acknowledge the work’s authorship and initial publication in SACJ. Should anyone else wish to make commercial use of the work, SACJ cedes the right to the author to negotiate terms and does not expect to be paid any royalties.
- Authors may enter into additional arrangements for non-exclusive distribution of the SACJ-published version of the work (e.g., post it to a repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are required to refrain from posting their work online prior to completion of reviews so as not to compromise double-blind reviewing or confuse plagiarism checks.